VIDEO
Also question is, what size should valley boards be?
In all cases valley boards should be fitted. Valley boards may be inset or continuous over the rafters. Where they are inset, they should be a minimum of 12mm thick and supported on bearers of 50 x 25mm or similar and set at a depth to suit the thickness of the Valley Board.
Similarly, how wide should a roof valley be? Nail along the edges every 12 to 18 inches, keeping the material tight against the roof sheathing. Metal valley linings should be 2 to 3 feet wide and no more than 8 or 10 feet in length to prevent wrinkling from lengthwise expansion.
Beside this, how do you fit Klober dry valley?
The Klober dry valley troughs are fitted onto the valley boards and should be firmly fixed from the Easy-Form® section upwards, using suitable large headed roofing nails on either side of the trough and through the top flat section of the water bar, at a minimum of 500mm centres.
How do you install roofing felt in a valley?
Tips for Applying Felt Paper to Roof Valleys
- Use a Broad Strip of Felt Paper. Felt paper should extend at least 10 inches up each side of the roof valley, so use a strip between 20 and 24 inches wide.
- Start at the Top. Lay the felt paper from the top of the roof valley to the eaves at the roof edge.
- Use Galvanized Staples.
- Trim the Felt Paper at Top and Bottom.
How does a dry valley form?
Gorges and dry valleys. During the ice age, underground water remained frozen while surface water melted. This forced the flow of meltwater over the surface and formed valleys and waterfalls. When the water could again flow underground, these features remained as dry valleys, cliffs and gorges.What is a dry ridge system?
Dry ridge refers to a method of mechanically fixing ridge tiles or hip ridge tiles to a roof without the use of traditional sand and cement mortar. Dry ridge system – This gives a brief overview of the dry fix system used to secure ridge tiles.What is Valleyboard?
Definition of valley board. : a board placed for the reception of the lead gutter in the valley of a roof.What is a lay board?
lay board. A board which is fixed on the rafters of a pitched roof to take the feet of the rafters, forming a subsidiary roof transverse to the main roof.What is Soaker code lead?
Code 4 lead is the perfect solution for either vertical cladding and soakers. You can also use it on a handful of other flashing applications. Unlike Code 3 lead, it is slightly thicker at 1.80mm and weighs 20.41kg per square meter.What is a lead Valley?
Lead lined valley. One of the areas of a pitched roof most prone to leakage if not constructed properly, is the valley. It is an area where water is directed towards, rather than away from, therefore correct detailing and construction is essential.How do you cut Dry Valleys?
The battens should be mitre cut to the angle of the valley, located on to the flat outer flanges of the Dry Valley and nailed to the supporting timber work outside the line of the Dry Valley. Tile the roof to within one full tile width of the central upstand the full length of the valley.How do you join two pitched roofs?
Position the flashing between the two roof pitches. Slide the right edge of the flashing under the highest roof pitch. Place the 2-by-4-inch piece of lumber along the center of the flashing. Gently bend the flashing using the edge of the lumber until both sides of the flashing match the slope of the two roof pitches. 
