- REMOVING THE FUEL FILTER AND LINE [top] 1. Remove the rear cover.
- Detach the carburetor.
- Disconnect the incoming fuel line.
- Remove the fuel filter.
- INSTALLING THE NEW FUEL FILTER AND LINE [top] 5. Install the new fuel filter.
- REASSEMBLING THE UNIT [top] 6. Reinstall the carburetor.
- Reinstall the rear cover.
Furthermore, which fuel line goes to the primer bulb?
One line goes from the fuel tank to the primer bulb, from the primer bulb to the carburetor, and back to the fuel tank.
Beside above, can you clean a leaf blower fuel filter? Wash the pre-filter in warm soapy water and then place the filter on a paper towel. Allow for at least one hour for the pre-filter to dry.
Likewise, people ask, how do I start Ryobi cs26?
Starting a Ryobi CS26 Trimmer After making sure the stop button isn't engaged, set the choke to "full", depress the throttle and pull the starting handle four times. If the engine doesn't start, set the choke to "half" and pull seven more times.
Which fuel line is the return line?
2. The second line is a clear yellow line. This line is the return line and it connects from the fuel tank grommet to the purge pump body to the connector closest to the air filter.
Where does the fuel line go on a carburetor?
Feed the line in through the gas tank, pull the fuel line into the gas tank and attach the weighted fuel filter to the end of the fuel line and the filter should lie in the bottom of the tank. The larger diameter fuel line connects to the other remaining fitting on the carburetor.How do you install a primer bulb?
Reviewing these steps will likely help with primer bulb replacements on other engines.- Access the carburetor.
- Unscrew the two carburetor mount screws.
- Remove the old primer bulb.
- Clean the carburetor and primer bulb components.
- Install the new primer bulb.
- Remount the carburetor.
